13
EN
FR
ES
IT
PT
DE
SECONDARY ZONES SETTINGS
IMPORTANT:
Can only be configured as second zones the zones controlled by a
wired zone module.
To configuration secondary zones, follow these instructions:
-
Perform the setup according to the next section.
-
Disconnect the controller from the secondary module. After a few seconds, this module will be available on the menu
of Linked zones.
-
Once all the secondary module, configure the module or modules main and associate the sub modules that you want
to each one of them.
Note:
It is recommended the use of a Blueface controller for configuring secondary zones.
INITIAL SETUP
Important:
Before performing the initial set up of the system, configure firstly the secondary zones, see
section.
Note:
It is recommended to firstly set the controllers which are going to be configured as main.
BLUEFACE AND THINK CONTROLLERS
Important:
Once the setup has been started, it must conclude. You will be able to modify the desired parameters later.
Language
Select your language. These are the available languages: English, French and Spanish.
To associate a wireless Think controller, start the radio channel search:
Setting wireless device
-
Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once
open, you have 15 minutes to make the association. If that period of time expires, start the
process over again. Remember not to open more than one module at the same time, it may
alter the process. You can also open the channel association radio through the Blueface and
Think (see section
System parameters
).
IMPORTANT:
not to open more than one radio channel at the same time, it may alter the process.
-
Start the radio channel search, to do so, press Airzone to start the search.
-
The controller will display the different wireless zone modules found, with the signal level of each one of them. Select
the wanted module and press “Check”, the selected module will begin to “beep” to be identified. Verify
the range is
correct
(30% minimum) and confirm.
IMPORTANT:
Before selecting the zone module associated to the controller, check that this module is the desired one. If this module
is not the correct one, use the control bar to select another module and check again.
IMPORTANT:
The controller will display first the wireless zone modules which are closer to it. Remember to configure this controller
near the wireless zone module to associate for greater comfort.
Units
(only if it has not been previously configured by any controller)
Select the units you want to use: Celsius (˚C) or Fahrenheit (˚F).
Zone ID
Select the zone associated to the controller. All the zones have a corresponding control output (output for motorized elements
or relay radiant heat control module). For example, the zone 1 will control the control relay output O1 of the relay radiant heat
control module.
