6
EN
FR
ES
IT
PT
DE
PRECAUTIONS AND ENVIRONMENTAL POLICY
PRECAUTIONS
For your security, and to protect the devices, follow these instructions:
•
Do not manipulate the system with wet or damp hands.
•
Disconnect the power supply before making any connections.
•
Take care not to cause a short circuit in any of the system connections.
ENVIRONMENTAL POLICY
Do not dispose of this equipment in the household waste. Electrical and electronic
equipment contain substances that may damage the environment if they are not handled
appropriately. The symbol of a crossed-out waste bin indicates that electrical equipment
should be collected separately from other urban waste. For correct environmental
management, it must be taken to the collection centers provided for this purpose, at the end
of its useful life.
The equipment components may be recycled. Act in accordance with current regulations on
environmental protection.
If you replace it with other equipment, you must return it to the distributor or take it to a
specialized collection center.
Those breaking the law or by-laws will be subject to such fines and measures as are laid down
in environmental protection legislation.
GENERAL REQUIREMENTS
Strictly follow the directions outlined in this manual:
•
This system must be installed by a qualified technician.
•
Verify that the units to be controlled have been installed according to the manufacturer's requirements and operate
correctly before installing the Airzone System.
•
Locate and connect all the devices of the installation in accordance with the electronic regulations in force.
•
Verify that the air conditioning installation to be controlled is in accordance with the regulations in force.
•
To install the flexible duct, follow the local recommendations for its ubication and isolation of the ducts to the damper.
Perform a cut along the isolated area to maintain the actuator of the damper outside it. Once finished, check the
tightness of the joints between the damper and the duct.
•
On zones controlled by wireless controllers, place the dampers and zone modules as close as possible to the wireless
controller of the zone.
