7
EN
FR
ES
IT
PT
DE
INTRODUCTION
Airzone systems enable the management of Main and Zone interfaces. Main thermostats enable mode management or user
mode and fan speed of the system.
-
Blueface Main: Mode, User mode icons shown in white color.
-
Blueface Zone: Mode, User mode and Speed icons shown in gray color.
-
Think Main: Accessing the settings menu, Operation mode and User mode are available.
-
Think Zone: Accessing the settings menu, Operation mode and User mode are unavailable.
SYSTEM INSTALLATION
Before performing the Airzone system installation, check:
The equipment to control has been installed according to the manufacturer’s criteria and it works correctly without
the Airzone system.
In direct expansion unit systems, the indoor unit wired thermostat has been installed.
Important:
For installations with radiant surfaces only, it is recommended the installation of buffer tanks.
In order to install properly your Airzone system, follow these steps:
Make all connections
(see Section
Connection
)
.
-
Connect all the elements of the system (thermostats, modules, etc.).
-
Configure the microswitch of the relay radiant heat control module.
-
Power the main control board.
Check all the assembly and the connection are correct
(see section
Assembly and connection evaluation
)
.
Configure the system.
-
Configure the secondary modules to associate them then to a main thermostat (see section
Subordinate zones settings
).
-
Configure all the thermostats (see sections
Initial setup
and
Advanced settings
).
If you have any other doubt, check the user and installation manuals.
Access all our technical documents and the self-diagnosis section, check the most FAQs,
certificates, watch our videos and read our declaration of conformity at:
myzone.airzoneusa.com
Don’t forget to download, complete and print the
Commissioning
document available on
myzone.airzoneusa.com to place it together with your installation.
