10
EN
On/Off. Pressing the icon turns the zone in which the thermostat is located on or off. This
button also indicates the system's operation mode. It has a range of colors:
Purple
: the system is shut down; the operation mode is Stop.
Red
: the operation mode is Heating.
Blue
: the operation mode is Cooling.
Green
: comfort; the set-point temperature has been reached.
If the button shows a steady light, the controller is switched on.
If the button is blinking, the controller is off.
The button remains steady for 10 seconds to show its status, and then it turns off.
23°
Set-point temperature.
Using the buttons you can raise or lower the set-point temperature
by up to 3°C (6 ºF) (in steps of 0.5 °C (1 ºF)) with regard to the base set-point temperature
defined in Lite settings parameter of the Blueface thermostat. (See Zone settings section).
The LED lights indicate the set-point temperature.
In the event that the temperature limit is exceeded, the temperature adjustment icons will
flash, indicating that you have reached the limit.
CHANGE OF BATTERY
Important:
The use of batteries from leading brands is recommended, similar to those
provided. A battery of lesser quality may have a reduced life.
Remember to place the old battery in an appropriate recycling bin.
Note: Remember to remove the anti-vandalism system (if installed) before removing the
thermostat from the wall.
When the low battery icon
appears on the display, the battery must be replaced.
Note: In the case of wireless Lite thermostats, a "Lite low battery" warning message will appear
on Blueface thermostats.
To replace the battery, separate the thermostat from its base and replace the battery (CR2450).
Basic functions
Summary of Contents for ZS6
Page 1: ...User s Manual Easyzone ZS6 S62 ES EN FR...
Page 24: ......
