Introduction to Operation ___________________________________________________
____________________________________________________________________ aitronic
5-7
Reading Transponder Tags
If there were barcodes captured before with the Standard Program switching to
transponder capturing by means of options menu item
Transponder
is required.
Hold the device so that the red bar code scanner window near to the transponder
tag and press the button
SCAN
.
The MDE device
responds to a successful reading with the decoding beep and
shows the read transponder id.
Manual Entries
Enter article number and quantity by using the buttons
1
...
9
. The cursor marks the
position of the next digit to be entered.
Input of alpha characters can be done by switching to alpha mode by means of key
. Then alpha input can be done by means of keys
0
...
9
. The concerning key must
be pressed such often until the desired alpha character is shown. Alpha mode can
be left by pressing key
again.
Use button
DEL
to delete the digit left to the cursor.
By pressing button
ENTER
the article number entry is
closed and
the cursor jumps
to the quantity field.
Pressing button
ENTER
during quantity input entry is closed and the record is
stored. The input mask will be cleared for the entry of the next article number.
Deleting Characters
By pressing button
DEL
the character left to the cursor will be deleted.
Deleting the Input Field
By holding down the button
and pressing button
DEL
at the same time the actual
input field will be deleted.
