7
CX-BK7
– DVD mechanism deck –
•
In checking the DVD mechanism deck section, prepare two extension jigs (Part No. J-2501-103-A: 1mm Pitch, 29 cores, Length
300mm/Part No. J-2501-248-A: 1mm Pitch, 27 cores, Length 300mm).
Note:
The DVD mechanism deck of this model is a vertical type and putting it vertically as shown in the figure is the standard position.
When checking signals such as RF waveforms, operate it with the DVD mechanism deck in the standard position as shown below.
– MAIN board, ACDC board and MB03 board –
•
For connecting the DVD mechanism deck, prepare three extension jigs. (Refer to “– DVD mechanism deck –”)
•
In checking the MAIN/ACDC/MB03 boards, prepare three extension jigs (Part No. J-2501-231-A: 1mm Pitch, 15 cores, Length 300mm/
Part No. J-2501-243-A: 1mm Pitch, 17 cores, Length 300mm/Part No. J-2501-265-A: 4 pin, Length 300mm).
Connect the extension jig (J-2501-248-A)
to the relay board (CN201) and
the main board (CN901).
Connect the extension jig (J-2501-103-A)
to the RF board (CN002) and
the MBO3 board (CN501).
front AMP board
SURAMP board
SP board
video board
Connect the extension jig
(J-2501-231-A) to the video
board (CN802) and the SP
board (CN312).
PT96 board
ACDC board
MB03 board
DVD mechanism deck
tuner unit
main board
front panel section
Connect the extension jig
(J-2501-243-A) to the video
board (CN801) and the MB03
board (CN105).
Connect the extension jig
(J-2501-265-A) to the ACDC
board (CN004) and the main
board (CN007).
