18
En
TIMER OPERATIONS
* Open the control panel with PANEL OPEN/CLOSE if needed.
Sleep timer
Turns off the unit automatically after a specified time.
1
Press SHIFT+SLEEP on the remote control.
"
SLEEP
" appears on the display.
2
Press
f
or
g
repeatedly to set the sleep
timer duration.
With each press, the timer duration changes in 5-minute
steps between 5 to 240 minutes. If there is no button input
for 4 seconds, the current setting is entered automatically.
The unit turns off after the selected time.
• MULTI JOG is also available in place of
f
or
g
.
To check the remaining time until the unit turns off
Press SHIFT+SLEEP on the remote control. The remaining
time is displayed for 4 seconds.
To cancel the sleep timer
Press SHIFT+SLEEP twice on the remote control so that
"
SLEEP oFF
" is displayed.
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1
Press one of the function buttons to select the
desired playback source.
2
Press TIMER (SHIFT+TIMER on the remote
control).
"
5
" indicator lights up and "
PLAY
" appears on the
display. Then, the timer-on time and the source name
appear alternately on the display.
3
Press
f
or
g
to set the timer-on time, then
press
a
SET or ENTER.
If
f
or
g
is not pressed within 6 seconds, you
will exit the timer setting mode and the previous setting,
however, is entered.
•MULTI JOG is also available in place of
f
or
g
.
4
Press
f
or
g
to set the timer-activated
duration, then press
a
SET or ENTER.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
If there is no button input for 4 seconds, the current setting
is entered automatically.
•MULTI JOG is also available in place of
f
or
g
.
5
Adjust the volume and tone for timed playback.
If the volume level is set to 17 or higher, it is automatically
turned down to 16 when the unit is turned on by the timer.
6
Prepare the source.
To play CD(s), load disc(s).
To play the radio, select the band and tune in to the desired
station.
To play a tape, insert the tape.
To play external equipment connected to the VIDEO/AUX
jacks, set an external timer for the equipment so that its
playback begins at the same time.
7
Press POWER
6
STANDBY/ON to turn the unit
off.
"
5
" remains on the display to indicate the timer standby
mode.
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
• Timer playback will not begin unless the unit is turned off
first.
• Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.
• The timer source can be changed with the function buttons
before completing step 3.
