9
En
Dimmer
Adjusts the brightness of the display.
1
Press ECO twice when the unit is turned on, and
then within 4 seconds press ENTER.
2
Turn MULTI JOG to select one of the three dimmer
modes or "
DIM-OFF
", and then press ENTER.
"
DIM-OFF
" is the brightest and "
DIMMER 3
" is the
dimmest.
If there is no MULTI JOG or button operation within 4
seconds, setting is canceled.
To cancel the dimmer
Repeat the above and select "
DIM-OFF
".
Setting the clock
1
Press CLOCK(SHIFT+CLOCK on the remote
control).
2
Press
f
or
g
to set the time.
Each press changes the time in 1-minute steps. Holding
it down changes the time in 10-minute steps.
If
f
or
g
is not pressed within 4 seconds, setting
is canceled.
•MULTI JOG is also available in place of
f
or
g
.
3
Press ENTER or
a
SET.
The time display stops flashing and the clock starts from
00 seconds.
To display the time
Press CLOCK(SHIFT+CLOCK on the remote control).
The time will be displayed for 4 seconds, but it cannot be
displayed during recording.
To switch to the 24-hour standard
Display the time and press
s
within 4 seconds.
With each press, the clock alternates between the 12-hour
standard and the 24-hour standard.
Tip:
In the 12-hour standard, "
AM 12:00
" indicates midnight
and "
PM 12:00
" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Re-set the clock.
ECO mode
Reduces power consumption with the following operations, etc.
ECO ON mode
- The unit blacks out when the unit is turned off. Only the red
indicator lights up. (Only when the clock is set.)
- If dimmer mode is set to on, the unit illumination brightens
(for 10 seconds) only when you operate the unit.
- When the unit turns on with the timer recording, the dimmer
mode is set to dimmest and the volume is set to minimum.
ECO AUTO mode
- In addition to the operations of ECO ON mode, the unit
automatically turns itself off if you do not operate the unit
for 10 minutes.
1
Press ECO once when the unit is turned on, and
then within 4 seconds press ENTER.
2
Turn MULTI JOG to select one of the ECO modes
and then press ENTER.
If there is no MULTI JOG or button operation within 4
seconds, the setting is canceled.
To cancel the ECO mode
Repeat the above and select "
ECO OFF
".
