En
PLAY WITH DOLBY PRO LOGIC
1 Start playback of the video source
2 Press the DOLBY PRO LOGIC button.
NORMAL is selected, and the playback sound has the DOLBY
PRO LOGIC effect.
To cancel DOLBY PRO LOGIC mode
Press the DOLBY PRO LOGIC button repeatedly until “P-oFF”
is displayed.
ADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 CH LOGIC modes.
To select PHANTOM or 3CH LOGIC
Press the DOLBY PRO LOGIC button to run through the mode
choices for selection in the following sequence.
Cancel
ENGLISH
22
DOLBY PR
O LOGIC
To adjust the balance of connected speaker sound levels
Carry out step 2 to 4 on page 21.
• Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
• BBE, DSP, and the vocal fader are automatically canceled when
the DOLBY PRO LOGIC is selected.
• The DOLBY PRO LOGIC is automatically canceled when any
of the DSP, BBE, or vocal fader effects are selected.
• The DOLBY PRO LOGIC is automatically canceled when
headphones are plugged in or there is audio input through a
microphone.
• The full DOLBY PRO LOGIC effect cannot be obtained when
using software without
H
mark. In this case, use
the SURROUND mode instead. (See page 8.)
NORMAL mode:
Use this mode when the supplied
front speakers, a larger-sized center
speaker and supplied surround
speakers are connected.
PHANTOM mode:
Use this mode when no center
speaker is connected. The center
channel signals are output through
the left and right speakers.
3CH LOGIC mode:
Use this mode when no surround
speakers are connected. This mode
reproduces rear sounds through the
front speakers.
