Purpose: To obtain compatibility with other VCR(VCP) Models.
DECK MECHANISM ADJUSTMENT
83
5-2. Confirm that the Tape passes smoothly
between the Take-up Guide and Pinch
Roller(using a Mirror or the naked eye).
1)
Afetr completing Step 5-1.(Preliminary Adjustment),
check that the Tape passes around the Take-up Guide
and Pinch Roller without Folding or Curling at the Top or
Bottom.
(1) If Folding or Curling is observed at the Bottom of
the Take-up Guide then slowly turn the Tilt
Adjustment Screw(C) in the Clockwise directioin.
(2) If Folding or Curling is observed at the Top of it then
slowly turn the Tilt Adjustment Screw(C) in the
Counterclockwise direction.
Check the RF Envelope after adjusting the A/C Head, if
the RF Waveform differs from Fig. C-5-4, performs
Precise Adjustment to flat the RF Waveform.
Test Equipment/ Fixture
• Oscilloscope
• Alignment Tape(SP)
• Screw ) Type 5mm
Connection Point
• Audio output jack
Test Conditions
(Mechanism Condition)
• Play an Alignment Tape
1KHz, 7KHz Sections
Adjustment Point
• Azimuth Adjustment Screw(A)
• Height Adjustment Screw(B)
1) Connect the Probe of the Oscilloscope to Audio Output
Jack.
2) Alternately adjust the Azimuth Adjustment Screw(A) and
the Tilt Adjustment Screw(C) for Maximum Output of the
1Khz and 7Khz segments, while maintaining the flattest
Envelope differential between the two Frequencies.
Adjustment Procedure
5-3. Precise Adjustment (Azimuth adjustment)
6. X-Value Adjustment
Fig. C-5-4
1KHZ
• Oscilloscope
• Alignment tape(SP only)
• Screw ) Type 5mm
• CH-1: PB RF Envelope
• CH-2: NTSC: SW 30Hz
PAL: SW 25Hz
• Head Swithching Output
Test Point
• RF Envelope Output Test
Point
Test Conditions
(Mechanism Condition)
• Play an Alignment Tape
Adjustment Point
Connection Point
Test Equipment/ Fixture
Adjustment Procedure
1) Insert the alignment tape, and press the + or - manual
tracking (channel) button once while "AUTO TRACKING"
is flashing on the screen to release auto tracking, and then
center the tracking.
2) Run the tape long enough for tracking to complete one
cycle.
3) Loosen the fixing screw, and move the A/C head base
assembly in the direction shown in the diagram, to find the
center of the peak so that the maximum envelope is avail-
able.
With this method, the 31-µm head can trace on the cen-
terof 58-µm track.
4) Tighten the A/C head base assembly fixing screw.
7KHZ
A:Maximum
B:Maximum
Left
Right
Groove at the
Base A/C
Height Adjustment Screw(B)
Tilt Adjustment Screw(C)
Azimuth Adjustment
Screw(A)
X-Value Adjustment Hole
Fixed Screw
RF ENVELOPE OUTPUT TEST POINT
OSCILLOSCOPE
HEAD SWITCHING OUTPUT TEST POINT
Connection Diagram
Adjustment Diagram
NOTE:
CH-1 CH-2
