ENGLISH
Preparing the remote control
Inserting the batteries
Caution
To prevent damage from leakage or explosion, follow
the descriptions below.
• Insert the two supplied R03 (size AAA) batteries with
the
0
and
9
marks correctly as illustrated.
• Do not mix old batteries with new ones or different
types of batteries.
• Do not throw the batteries into a fire, apply heat to
them or take them apart.
• Do not carry the batteries with keys or other metallic
objects.
Note
Remove the batteries when they have no more power, or when
you do not use the remote control for a long period of time.
Using the remote control
Point the remote control toward the remote sensor.
Notes
• The remote control may not operate when there is any
obstruction between the remote control and the remote
sensor.
• Strong ambient light sources such as a fluorescent lamp or
direct sunlight may cause unreliable operation.
• Using a TV with the same type of infrared remote control
facing the same direction may cause incorrect operation.
• The maximum distance for effective control between the
remote control and the remote sensor is 7 meters.
• Although you can use the remote control within an angle of
up to 30 degrees in any direction from directly in front of the
remote sensor, we recommend a narrower angle for stable
operation.
• During Power Save mode, the remote control does not
operate.
Remote sensor
Tuning your TV to the VCR
When using the VCR, the signals passes from the antenna
to the VCR and then out to the TV. Before you use your
VCR, a video output channel must be set on your TV.
If you have connected the VCR to the TV with a 21-pin scart
cable, this procedure is not necessary.
Press POWER on the remote control to turn on
the VCR.
Make sure your TV is turned on.
Select a spare channel position on the TV and
tune the TV so that the blue screen appears
clearly on the TV screen.
Refer to the TV operating instructions for tuning.
Whenever you want to play back a tape, select this
channel position.
If there is interference on the
picture (wavyline, picture roll, etc.)
During power off, press and hold CHANNEL
N
and
M
on the VCR simultaneously for
more than 4 seconds.
“RF C36” appears in the display window.
Press CHANNEL
N
or
M
to select another
channel.
You can select any number between 22 and 68.
Tune the TV so that the black and white test
pattern appears clearly on the TV screen.
Refer to the TV operating instructions for tuning the TV
picture.
Press POWER to turn off the VCR.
The VCR is now tuned to your TV. Whenever you want
to use the VCR, select the VCR channel on your TV.
If there is still interference on the TV
screen
Connect the VCR to the TV with an optional 21-pin scart cable.
You do not have to tune in a dedicated VCR output channel.
Whenever you want to play back a tape, simply select a
channel on your TV called AV.
You can set RF out to OFF in step 2.
Tip
If “RF C36” does not appear in the display window in step 1, the
VCR is in Power Save mode. In this case, turn on the VCR, and
press POWER on the remote control to turn the VCR off. Then
perform step 1 again.
CHANNEL
N
/
M
1
2
1
2
3
4
4
30
7m
30
TIMER
VCR
REM BILSAP
ST
SP LP EP
M
REC
Hi-Fi
POWER
