19
En
To display the timer setting
Press SHIFT+TIMER on the remote control.
The timer-on time, the source and the timer-activated duration
are displayed for 6 seconds.
Tip:
Timer setting can be displayed even while the unit is turned
off, and at that time if you press ENTER or
a
within 6 seconds
after SHIFT+TIMER is pressed, you can enter the timer setting
mode and change the setting.
To change the timer setting
Re-set the timer again.
To cancel the timer
Press SHIFT+TIMER on the remote control repeatedly until
"
OFF
" is displayed. "
5
" disappears from the display.
Tip:
Your timer setting is retained even if the timer is canceled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
Timer recording
Timer recording is available only for TUNER and VIDEO/AUX
(with an external timer) sources.
1
On the remote control, press SHIFT+TIMER
repeatedly to display "
REC
" and press ENTER.
If ENTER is not pressed within 6 seconds, you will exit
the timer setting mode and the previous setting, however,
is entered.
On the unit, press MODE repeatedly to display
"
TIMER
", and press ENTER within 4 seconds.
Then turn MULTI JOG within 6 seconds to select
"
REC
", and press ENTER twice within 4
seconds.
2
Carry out step 2 to step 5 described in "Timer
playback".
3
Prepare the source.
To record the radio, select the band and tune in to the
desired station.
To record external equipment connected to the VIDEO/
AUX jacks, set an external timer for the equipment so that
its playback begins at the same time.
4
Insert the recording tape in DECK 2 and then turn
the unit off.
Tip:
The display is dimmed while the timer recording is active.
