– 6 –
(6)
Apply the hook on one side to the anode button as shown
on the figure. (See Figure 3-6)
Caution :
Check that the hook is held securely.
(7)
Apply the hook on the other side to the anode button as
shown in Figure 3-7.
(8)
Pull the anode cap slightly with the rubber cap turned
over and visually check that the hook is engaged securely.
(9)
Release your hand from the rubber cap of the anode cap.
Caution :
Cover the anode cap so that it does not lift.
(10) Hold the skirt of the andoe cap slightly to improve the
close contact between the cap and CRT.
(11) Check that the anode cap is in close contact with the CRT.
(See Figure 3-8)
Figure 3-8
Figure 3-7
Figure 3-6
Anode button
Skirt
Hook
Anode button
Anode button
Hook
Anode button
Hook
30
°
