– 18 –
3-4.
SUB COLOR Sub-color Adjustment / Adjustment Menu Screen : PAGE 3-4
Input signal : Color bar
VIDEO IN
Measuring instrument : Oscilloscope
Pattern generator
Test point : TP302/BT301(wire connector) 3 pin
1. Connect oscilloscope to TP302
2. Use the volume keys of the jig remote controller and adjust the top and bottom
excursions of waveform to be linear as shown in the Fig. 3-4.
4. TV SETTING CHECK Checking of Setting per Model Basis / Adjustment Menu
Screen : PAGE 1~4
The setting details are fixed per model basis. Do not set other than specified.
• Check whether the adjustment menu screen is matching to the table-4. If not, use the
volume keys on the jig remote controller to search and set the matching menu screen to
the model.
3.58 TRAP
0 : ON
BPF
2 : AUTO
H AFC
1 : +1
WPL
0 : OFF
5-1. ATT ALIGNMENT ATT Adjustment / Adjustment Menu Screen : PAGE 5-1
Input signal : ANT RF-Input
Measuring instrument : Oscilloscope
Test point : IC701 2 pin TV-L
1. Connect oscilloscope to TP702 (IC701 2 pin)
2. Use the volume keys on the jig remote controller and adjust the figure for IC701 2 pin
to 490V
±
20m Vrms.
5-2. SEPARATION ALIGNMENT Stereo Audio Segregating Adjustment / Adjustment
Menu screen : PAGE 5-2 to 5-3
Input signal : Setting of TV audio multiple signal
equipment
* The contents for 3.58 TRAP can not be modified.
Table-4
Modulation
Internal
Internal
400Hz
Modulation
Audio
L ch
Channel
2 ch
Video Signal
Color Bar
• RF output for Audio multiple signal generator/2CH
Measuring instrument : Oscilloscope
TV audio multiple signal generator
