3.JITTER CHECK
1) While oscilloscope is kept connected in the same test point as in step2. RF
WAVEFORM CHECK, connect the output terminal of an oscilloscope to the input
terminal of the jitter meter.
2)
Set the VOLT range selector of oscilloscope to 500mV range or below.
3)
Play back 2
nd
track of TCD-782.
4)
Check that jitter meter indicates 28.0ns or less.
4. PLAY ABILITY CHECK
1)
Play back the 3
rd
, 8
th
and 13
th
track of ATD-001. Check that the noise does not occur sound skipping does not occur.
5.LASER CURRENT CHECK
*Do not perform this measurement unless the laser is suspected to be defective.
1)
Connect digital multi-meter across the resistor R402(10
Ω
).
2)
Play back the TCD-782 and check the DC voltage value on the digital multi-meter.
3)
Calculate the laser current (Iop) by dividing the DC voltage across R402 by the
resistor value (R402= 10
Ω
). Check that the laser current (Iop) is 60mA or less.
OUTPUT
ns
OSCILLOSCOPE
JITTER METER
INPUT
RF SW
Vref
V
DIGITAL MULTIMETER
R402
R402
-32-
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
