Page 19
The final step for assembly is attaching the wings.
Heat the area around the large slot to attach the
covering. Trim the covering from the slot for access to
the aileron servo wire. There is a hole just forward of the
slot for the wing thumb screw. Trim the covering from
this hole too.
Slid in and center the carbon fiber wing tube.
Slide the wings onto the carbon fiber tube and secure
using the thumb screw.
Radio Installation & Setup
Your receiver can be mounted anywhere in the airframe.
A piece of foam rubber should be used between the
fuselage and the receiver to dampen any vibration.
Use the suggested throws below as your starting point
then fine tune to your flying preferences after your first
few flights.
Take the time to properly balance and trim your aircraft.
The center of gravity range is located from the back edge
of the carbon fiber fuselage support to 10mm back.
To test the CG fly left or right at about 3/4 to full throttle
and pull to a 45 degree up-line. Roll inverted and let go
of the elevator stick. A correct nose heavy CG will slowly
arc to the level. A neutral CG should nearly hold the up-
line. And a tail-heavy CG will steepen the up-line.
While the final setup is of personal preference, these are
some general guidelines to make your first flight a
success.
Control Throws
Elevator
10° Up
13° Down
Aileron
12° Up
12° Down
Rudder
15° Left
15° Right
