3
2
1
NO.49
2
|
01252 359760 • ajproducts.co.uk
Problem
Turning direction of Nut (36)
Fork not lifted up
- (counter clockwise)
Fork not lowering down
+ (clockwise)
Slow lifting no function
+ (clockwise)
Quick lifting not possible
- (counter clockwise)
Operating manual
SAFETY INSTRUCTIONS
1. INSTRUCTIONS FOR SAFE OPERATION
2. HANDLE ADJUSTMENT
3. WHEN TO ADD OIL
4. INTENDED USE
Important
The instructions and safety instructions in this operating manual must be
followed to the letter. Failure to follow them or incorrect operation or abuse may
result in danger:
- for the operator or third parties
- for the unit and other property of the operator
The unit may only be operated and serviced by persons:
- who are trained to do so
- who have read and understood this operating manual
- who are acquainted with the safety regulations governing their work station
- who have a suitable work station and tools
Please refer to all the warning symbols and notes in this
description and on the unit before you commission it.
1. PEOPLE OTHER THAN THE OPERATOR MUST KEEP A SAFE DISTANCE
FROM THE UNIT WHILST IT IS OPERATING.
2. ONLY PEOPLE ACQUAINTED WITH THE UNIT SHOULD BE ALLOWED
TO OPERATE IT.
3. DO NOT COMMISSION THE UNIT UNTIL YOU ARE CONVINCED THAT
IT IS PERFECT CONDITION. PAY SPECIAL ATTENTION TO THE
CONDITION OF THE WHEELS, THE LEVER DEVICE, THE FORKS AND
THE RAISING AND LOWERING CONTROL.
4. NEVER USE THE UNIT ON SLOPES.
5. ENSURE THAT PARTS OF THE BODY BECOME CAUGHT IN THE
LIFTING MECHANISM, UNDER THE FORKS OR UNDER THE LOAD.
NEVER TRANSPORT PEOPLE ON THE UNIT.
6. THE OPERATOR SHOULD WEAR GLOVES AND SAFETY SHOES FOR HIS
OR HER OWN SAFETY.
7. NEVER TRANSPORT UNSTABLE OR LOOSELY STACKED OBJECTS.
8. NEVER OVERLOAD THE UNIT.
9. NEVER LOAD THE PLATFORM ON ONE SIDE OR MAKE IT TOP-HEAVY
OR PLACE LOADS THAT STICK OUT OVER THE EDGE OF THE PLATFORM.
10. THE CAPACITY OF THE UNIT ASSUMES THAT THE LOAD WILL BE
PERFECTLY BALANCED FOR TRANSPORT WITH THE CENTRE OF GRAVITY IN
THE CENTRE OF THE FORKS AT THE FRONT.
11. ENSURE THAT THE LENGTH OF THE FORKS IS THE SAME AS THE
LENGTH OF THE PALLET.
12. LOWER THE FORKS AS FAR AS POSSIBLE WHEN THE UNIT IS NOT IN
USE.
This pallet truck lifting by both manual and electric, lowering by manual.
There are 3 different positions with different functions for the
Control Handle (49).
Position 1: to raise the forks
Position 2: to drive the unit
Position 3: to lower the forks
Release lever
Test different functions by putting the Handle (49) in 3 different positions
respectively.
If it does not function properly, then adjust the Nut (36).
If the fork can’t be pumped up to its rated highest position, you may have to add
hydraulic oil into the oil tank. The hydraulic fluid to be used must have a quality
of ISO VG32 or equivalence, its viscosity should be 1,5 – 3,5. Mixing of different
fluids is prohibited!
The high-lift pallet truck, with forks for independent lifting of loads, is intended for
both manual lifting/lowering and the manual transporting of loads. Its use
requires a level and firm floor/ground surface.
