12G-AMA v1.0 8 www.aja.com
CLASS 1
LASER
PRODUCT
Warning! Active fiber-optic cables emit radiation invisible to the human eye. Do
not look directly at the end of an active fiber-optic cable or the fiber connector
on a
12G-AMA-R, 12G-AMA-R-ST, 12G-AMA-T, 12G-AMA-T-ST, or 12G-AMA-TR
;
these models are Class 1 Laser Products.
Figure 2. 12G-AMA to Fiber LC Single Channel SFP Example
NOTE: Fiber optic interconnections can be severely compromised by dirt, oils, or other
contaminants. All dust caps should be replaced on cables and equipment
whenever
12G-AMA
converters are disconnected from fiber optic cables.
4. Connect the breakout audio cable to the converter.
5. Connect audio equipment to the breakout cable.
6. Apply power to the converter (AJA power supply included).
7. The converter will now run using the default factory settings. If you wish to
alter the factory settings you can either:
• Change the DIP switch 2 - 8 settings.
- or -
• Install the AJA Mini-Config software on your computer,
• attach the converter via USB,
• change the DIP switch 1 setting to LOCAL, and
• make your changes using the Mini-Config setup screens.
NOTE: For highest reliability, the mini converter relies on convection cooling instead
of using a built-in fan. Therefore, when installing the unit, mount in a location
where it has access to air for proper cooling. Do not stack the 12G-AMA with other
mini converters.
