3G-AM Mini-Converter v1.0
www.aja.com
7
User Controls
DIP Switches
The 3G-AM has an 8 position DIP switch accessible through a cut-out in the bottom of
the unit. The DIP switches are used to configure the unit’s audio embedding and
disembedding, and control ancillary data.
Factory default switch settings are all in the leftmost position.
The exact functions of the DIP switches are described in
.
MiniConfig Control
The MiniConfig application can also be used to configure the unit’s audio embedding
and disembedding functions. Configuration set via MiniConfig is stored in the unit
through subsequent power cycles.
Installing and using MiniConfig are described in
Installation
Typically, 3G-AM installation consists of the following steps:
1. Ensure the converter is disconnected from power.
2. Connect video equipment to the converter BNCs.
3. Connect the breakout audio cable to the converter.
4. Connect audio equipment to the breakout cable (see
).
5. Apply power to the converter (AJA power supply included).
6. The converter will now run using the default factory settings. If you wish to alter the
factory settings you can either:
• Change the DIP switch 2 - 8 settings.
- or -
• Install the AJA MiniConfig software on your computer,
• attach the converter via USB,
• change the DIP switch 1 setting to LOCAL, and
• make your changes using the MiniConfig setup screens.
1 2 3 4 5 6 7 8
DIP Switch Setting
LEFT RIGHT
LOCAL
ON
ON
ON
ON
1/2
1/2
ON
CONTROL
EMBD 1/2
EMBD 3/4
EMBD 5/6
EMBD 7/8
EMBD GRP
DISEMBD GRP
PASS HANC
REMOTE
OFF
OFF
OFF
OFF
3/4
3/4
OFF