CION v1.1
www.aja.com
64
“Press Stop”:
May appear if you attempt to enter the menu parameters while you are recording or
playing back. If you want to enter the menu parameters, you must stop recordings or
playback. (The only exception to this rule is the use of the STATUS menu which may be
entered even during recording or playback to evaluate settings.)
“WARNING Dropped Frames”:
May appear if media is under-performing and cannot keep up with the data rate required
to make a recording or perform a playback. If you see this prompt during recording,
recordings will stop. If this prompt appears, you might consider backing up your current
recordings and formatting the Pak media. For playback, you might simply re-attempt
playback.
“WARNING Media Low”:
Will appear when the Pak media only has 15% of capacity remaining. Media must be
switched out when it reaches 10% of capacity. With 10% of media remaining, the
“WARNING Media Full” prompt will appear.
“WARNING Media
Unformatted”:
May appear if CION does not recognize the file system on the Pak media or the media has
never been formatted.
“WARNING Storage Removed”:
Will appear if the media is removed without first hitting the Media Unmount Button to
properly unmount it. In the event this happens, media immediately re-inserted into the
CION may show clips as “N/A” and subsequent recordings may not be possible. To resolve
this issue, mount the media on an Apple computer under Mac OSX, then remove and re-
insert the media into your CION. If the media does not read properly, you will need to
format it. Additionally, this alarm may lead to the “Please Reboot” prompt.
“WARNING Please Reboot”:
Appears if Pak media was removed without the use of the Media Unmount Button and
CION cannot continue operating and must be rebooted.
“WARNING Backup and
Reformat”:
May appear if the media has issues being mounted by CION. As the prompt indicates, it is
best to back up the media by copying it to another hard drive or disk array and then
reformat the media. Some signs that the media is in a read-only state: even though clips
have been recorded to the media, “N/A” appears in the clip area of the UI, “Loading”
appears in the clip area of the UI but does not eventually load a clip, or hitting the record
button with all settings correctly configured for CION does not result in a recording.
“WARNING Media In Use”:
Appears if you attempt an operation while the media is still performing a task; if the
alarm persists, you may consider powering down the CION and evaluating the media on
a computer.
“WARNING Name In Use”:
Appears if the clip name specified in the naming parameters already exists on the media.
This happens when take 999 is reached and no more take numbers are available. CION
will refuse to overwrite the clip. You will have to delete the clip or select a new name.
“WARNING No Clip Name”:
Appears if you attempt to record in gang mode using a non-existent custom clip name.
“WARNING Genlock Missing”:
Appears if you choose “Ref In” for 6.1 Genlock and no genlock is detected on the selected
input.
"WARNING Invalid Selection":
May appear if an unsupported menu selection has been made.
Summary of Contents for CION
