FS2 v2.1r1
www.aja.com
33
Mac Ping Procedure
1. Find the Utilities Folder inside of the Applications Folder.
2. Locate the “Terminal” utility application and double-click it.
3. On the FS2, select the
CONFIG
button and go to parameter menu 2.2 to read the IP
address.
4. At the Mac terminal prompt, enter
ping
and the IP address noted in step 3.
For example: ping 192.168.0.2
5. If successful, the ping utility will respond that packets were sent, received and how
long it took. For example:
64 bytes from 192.168.0.2: icmp_seq=0 ttl=64 time=0.590 ms
6. If unsuccessful, check the FS2 network settings and resolve the problem with your IT
administrator.
Windows PC Ping
Procedure
1. From the Start button, select the All Programs menu.
2. Select Accessories/Command Prompt from the All Programs list.
3. On the FS2, select the
CONFIG
button and go to parameter menu 2.2 to read the IP
address.
4. In the PC
Command Prompt
utility, enter
ping
and the IP address noted in step 3. For
example: ping 192.168.0.2
5. If successful, the ping utility will respond that packets were sent, received and how
long it took. For example:
64 bytes from 192.168.0.2: icmp_seq=0 ttl=64 time=0.590 ms
6. If unsuccessful, check the FS2 network settings and resolve the problem with your IT
administrator.
Web Browser Control
To control the FS2 from a web browser on a network attached computer, enter the FS2 IP
address as a URL in the browser. For example, if the FS2 IP address were “90.0.6.31”, you
would then type into the web browser: http://90.0.6.31. This topic is explained in greater
detail in
Chapter 5: Browser Remote Control.
NOTE:
The webUI (browser GUI) will keep up with most changes initiated at the front panel.
However, the webUI may not reconnect (displays “Disconnected”) when network changes are
initiated at the FS2 front panel. To manually reconnect, type the new IP address into the
browser, or click the browser Refresh button. Sometimes the browser caches the old FS2
address. If you can't get the browser to connect, try clearing the Browser history to clear the
cache, and then enter the new address again.
Software Update Installation
Although the FS2 comes from the factory pre-installed with software, it may not be as
up-to-date as software posted on our AJA website. This topic describes the steps
required to update the software in your AJA FS2.
Download the
Latest FS2 Software
Current and past releases of FS2 software are available on the World Wide Web from
AJA's website. To get the software, point your browser to the FS2 support page, which
will contain helpful FS2 information and links to the updates
USO
RESTRITO
