FS2 Frame Synchronizer/Converter v3.0 79 www.aja.com
6.17-24 Audio Delay Ch1/2-15/16 (mS)
These parameters apply only when the audio input (parameter 1) is set to Stereo
Map. The parameters allow you to adjust the stereo audio delay to compensate
for video timing (delay/latency). The default is zero delay).
Variable
Adjustment range increments from -16 to +256 mS or -768 samples
to +12288 samples.
Default=0 (synchronized to video output).
NOTE: This menu is not displayed when Dolby Framer Sync is in control of the delay
for a channel-pair. While Dolby Framer Sync is enabled, and the Dolby Framer
Input is assigned to channels x/y, any values assigned for the Audio Delay Ch x/y
parameters are ignored, and those menus are hidden.
If parameter 3 Audio Follow Video is set to On, the Audio Delay selection is
independently kept for each video input. If Audio Follow Video is set to Off, a
single Audio Delay value applies, regardless of the video input. (This value is
independent of any of the values used in Audio-Follow-Video mode.)
Audio Output Level Controls
7.0 Audio Out Levels
This parameter enables or disables individual audio output level adjustment of
the 16 audio output channels. When ADJUST is selected, parameters 7.1 through
7.16 set the output levels for each separate channel.d
Unity (default)
Adjust
Disable audio output level adjustments and set levels to unity.
Enable audio output level adjustments for the 16 audio channels.
If parameter 3 Audio Follow Video is set to On, the Audio Output Levels selection
is independently kept for each video input. If Audio Follow Video is set to Off,
a single Audio Output Levels value applies, regardless of the video input. (This
value is independent of any of the values used in Audio-Follow-Video mode.)
7.1–7.16 Audio Level Ch1–16
These 16 parameters adjust the audio levels of the 16 audio channels ± 18dB dB.
Variable
Adjustment of audio level +/-18 dB range in steps of 0.5dB.
Default: +0dB
Audio Output Phase Controls
8.0 Audio Output Phase
This parameter enables or disables individual audio phase adjustment of the 16
audio output channels. When Adjust is selected, parameters 8.1 through 8.16 are
then used to adjust phase for the 16 channels.
Unity (default)
Adjust
Disable audio phase adjustments and set phase to unity.
Enable audio phase adjustments for the 16 audio channels
If parameter 3 Audio Follow Video is set to On, the Audio Output Phase selection
is independently kept for each video input. If Audio Follow Video is set to Off,
a single Audio Delay value applies, regardless of the video input. (This value is
independent of any of the values used in Audio-Follow-Video mode.)
