FS3 Frame Synchronizer/Converter v1.1r1 11 www.aja.com
meet your individual facility requirements, and must be accounted for when you
configure the FS3 video output format.
Sidebar Video Keying
The FS3 can be configured to perform sidebar keying (useful when converting
with different image aspect ratios). Sidebar keying black or matte is available.
Retained Settings
The FS3 stores the current value of each operational parameter in Flash memory
so that the system returns to the same state after a power cycle.
The FS3 also stores independent values for many settings, so that if the unit
is configured for one operation, changed to a different operation, and then
returned to that prior operation, the settings for that prior operation are restored.
For example, changing the Video Input selection automatically selects new values
for Proc Amp parameters and RGB Proc Amp parameters. This is referred to as
Source Memory. Each video source remembers its own Proc Amp settings.
Similarly, changing the Output Format selection automatically selects new values
for H & V timing parameters. This is referred to as Output Timing Memory. Each
Output Format mode remembers its own H & V timing settings.
As another example, Output Format Mapping stores the Output Format selected
for any of the frame rates. That Mapped Output Format is recalled if the frame
rate selection is changed.
Forty different presets are available that can be used to restore the FS3 to a
previous state. Many parameters can be individually reset to factory values using
individual menus, or the entire FS3 can be reset to defaults (with the PRESET,
Factory Preset menu).
In This Manual
Chapter 1: Introduction provides an overview and a list of box contents.
Chapter 2: Controls, Indicators, and Connections describes controls, indicators,
and connections.
Chapter 3: Installation and Configuration provides complete instructions for
installing and configuring the FS3.
Chapter 4: Display Menus explains how to use the controls and display menus.
Chapter 5: Browser Control explains how to use the FS3 remotely via a web
browser on a network-attached computer.
Chapter 6: SNMP discusses FS3 support of SNMP.
Appendix A: Specifications presents a list of technical specifications for the
product.
Appendix B: Pinouts explains the rear panel connector pinouts.
Appendix C: About SDI Formats provides a basic history of some of the SDI
standards.
Appendix D: Safety & Compliance provides regulatory compliance statements,
advisories and warnings.
Warranty and Index
