FS3 Frame Synchronizer/Converter v1.1r1 46 www.aja.com
5 Genlock Source
This parameter selects the source of reference video used for genlock, either
automatically or explicitly.
Reference (default)
Input
Free run
Use the signal on the
Ref
connector as the genlock source.
Use the input signal as the genlock source.
Free run mode (FS3 syncs to its own timebase, not locked to an
external source).
6 Output Frame Rates
This parameter selects the HD video frame rate associated with the video
standard.
59.94/23.98 (default)
50/25
24
Select
59.94/23.98
if your desired rate is either 59.94
or 2
3.98.
Select
50/25
if your desired rate is either 50 or 25 (PAL).
Select
24
if your desired rate is 24.
NOTE: Changing the Frame Rates selection automatically selects a new value for
Video Output Format" on page 47
.
NOTE: Each Frame Rates selection remembers its own Output Format settings.
VIDEO PROC Menu Group
The following descriptions explain the Video Proc Menu Groups. The Video Proc
menu displays are formatted as follows:
Display
Description
MENU # TITLE
PARAMETER VALUE
INPUT FORMAT
Menu number and title.
Currently selected parameter value for this menu.
Video Processor Input Output Format
The currently selected Input video source and output video format is reported on
the bottom line of each menu.
1 Input
SDI1
(default)
SDI2
SDI DualLink
Fiber1
Fiber2
Fiber DualLink
Select SDI1 as the input source.
Select SDI2 as the input source.
Select SDI DualLink, linking both SDI inputs as the input source.
Select Fiber1 as the input source.
Select Fiber2 as the input source.
Select Fiber DualLink, linking both Fiber inputs as the input sources.
Source Memory
Changing the Video Input selection automatically selects new values for Proc
Amp parameters and Color Corrector (RGB) parameters. Each video source
remembers its own Proc Amp and Color Corrector settings. This is referred to as
Source Memory.
Dual Link
Dual Link referred to here is 1080p50/59.94 on two 1.5 Gb HD-SDI connections.
Selecting Dual Link as the Video Input will allocate both SDI Inputs for Dual Link
use. The Fiber inputs operate the same way.
