www.aja.com
63
FS4 Frame Synchronizer/Converter v1.1
7 Mix Down Reset
This parameter resets all of the mix down levels (five or seven input, two output) for the
selected mixer to the factory defaults. Turn the ADJIUST knob to select the mixer. Two
mixers are available in Four Channel Mode, and only one mixer is available in Single
Channel mode. After selecting a mixer, press ADJ. An “Are you sure” prompt is displayed.
Pressing
ADJUST
again resets that mixer...
8 Global Audio
Output
This parameter allows routing the same source or set of sources to all the FS4 audio
outputs. The rules used for Audio Out apply if the number of outputs do not match the
number of inputs.
NOTE:
No Global Map source is available.
9 Reset Mapped
Output
This parameter resets the selected output map to the factory default values
Mix Down 1
Mix Down 2 (4Ch only)
Resets the Mix Down 1 mixer levels to default settings.
Resets the Mix Down 2 mixer levels to default settings.
Off (default)
No Global output configuration is imposed. When Off all other
AUDIO OUTPUT menus are enabled and displayed.
SDI1
SDI2-8 (4Ch only)
AES.EBU
MADI BNC
MADI Fiber
The selected source channels are routed to all the FS4 audio output
channels.
Sig Gen 1KHz
Sig Gen 400Hz
Mute
The selected tone or mute is routed to every FS4 audio output
channel.
Mix Down 1 L:R
Mix Down 2 L:R (4Ch
only)
The stereo output of Mix Down module is routed to all the FS4 audio
output channels. The Left mixer channel goes to FS4 output
channel 1 and the Right mixer channel goes to output channel 2. If
the output has more than two channels (i.e. embedded SDI), mute
(silence) is routed to the higher numbered output channels.
Choose a Map (default)
Prompt for selecting an Output to map.
SDI1
SDI2-8 (4Ch only)
AES.EBU
MADI BNC
MADI Fiber
After selecting an output, press
ADJUST
to reset that output to the
factory default mapping (i.e. SDI1 to SDI1, SDI2 to SDI2, etc.).
All
Sets all outputs to their factory default mappings.
