www.aja.com
57
FS4 Frame Synchronizer/Converter v1.1
3.3 Subnet Mask
This parameter determines the subnet mask used by the FS4 for TCP/IP networking.
Consult your network administrator about how to set this value.
3.4 Default Gateway
This parameter determines the gateway or router used on your LAN for TCP/IP
networking. Consult your network administrator about how to set this value.
Without a properly configured default gateway (whether you have a router/gateway or
not), the FS4 will be unable to see other FS units on the network, although you may still
be able to control this unit via a web browser. Also, without a proper gateway defined,
the discovery feature on the
Network
web page will fail to list other FS units on the
network.
3.5 MAC Address
(view only)
Selecting this parameter allows you to view the MAC address. The MAC address is a
unique value associated with the FS4’s internal network adapter. MAC addresses are also
known as hardware addresses or physical addresses. MAC addresses uniquely identify an
Ethernet adapter on a LAN.
MAC address format: MM:MM:MM:SS:SS:SS
The value is 12-digit hexadecimal, where the first half identifies the manufacturer and the
second half identifies the unique serial number.
4 SNMP Enable
Parameters
The following parameters are used to setup the FS4 SNMP (Simple Network Management
Protocol) feature.
• 4.0 SNMP Enable
• 4.1 SNMP Trap Destination 1
• 4.2 SNMP Trap Port 1
• 4.3 SNMP Trap Destination 2
• 4.4 SNMP Trap Port 2
Refer to
for a description of SNMP and how the FS4
supports it.
About FS4 Alarms
The following FS4 alarm parameters affect how the front panel LEDs and Web UI report
error conditions. When suppressed, front panel LEDs will not light red, and the Web UI
will not report that particular error status. Suppressed alarms do not affect the
information reported on the FS4 front panel Status menus, and does not affect SNMP
messaging.
Subnet Mask variable
Enter a subnet mask compatible with your LAN. This is only needed
for Static IP configurations.
If
IP Config
is set to DHCP, the Subnet Mask is set by the DHCP server
and cannot be changed by the user.
If
IP Config
is set to
Default Addr,
the default
Subnet Mask
is
255.255.255.0
Gateway Address variable
Enter the address of the gateway or router used to connect the
FS4 to the network.
Default:
192.168.0.1
