www.aja.com
85
FS4 Frame Synchronizer/Converter v1.1
AES/MADI Menus
When AES is selected, Level and Phase parameter menus for AES and MADI input audio
are displayed. These menus are the similar to those used for Embedded Audio SDI1 Level
and Phase.
1.0 AES Level
Sixteen AES Level menus (and related submenus) are available.
2.0 MADI BNC Level
Sixty four MADI BNC Level (and related submenus) are available.
3.0 MADIFIB Level
Sixty four MADI Fiber Level (and related submenus) are available.
NOTE:
For level adjustment information, see
4.0 AES Phase
Sixteen AES Phase menus (and related submenus) are available.
5.0 MADI BNC Phase
Sixty four MADI BNC Phase (and related submenus) are available
6.0 MADIFIB Phase
Sixty four MADI Fiber Phase (and related submenus) are available.
NOTE:
For Phase adjustment information, see
DELAY Menu Group
IMPORTANT:
The settings in this menu group apply to the currently selected audio category (EMBED
or AES/MADI). These settings are shared with both Four Channel and Single Channel
modes.
The DELAY Menu Group provides delay adjustments for SDI Embedded, AES, MADI BNC,
and MADI Fiber input audio. Delay adjustments are applied to audio channel pairs.
EMBED Delay
Menus
When EMBED is selected, the following SDI Embedded Audio menus are available.
1.0 SDI1 Delay
This parameter selects the Audio Delay Mode for the eight SDI1 audio input channel
pairs. Delay operates on channel pairs only. Delay cannot be adjusted on any single
channel. Channel pairs are grouped as: Channel 1 and 2, Channel 3 and 4,…, Channel 15
and 16. The default Global setting applies the currently set Global delay value to all eight
input channel pairs. The factory default Global setting is 0 seconds delay, but whatever
value the user changes this setting to will be applied when Global is selected.
When Channel Pair mode is selected:
• Each of the individual eight SDI1 audio input channel pair delay values are applied to
the input delay of each channel pair.
• The range of delay is -128 to +12288 in units of samples where 48 samples = 1
millisecond.
Switching from Global to Channel Pair will apply the individual delay values that were set
for each individual channel pair. Switching from Channel Pair to Global will apply the
same currently set Global delay value to all the channel pairs.
Global (default)
Channel Pair
All eight SDI1 audio input channel pairs are set to the current Global
delay value. Individual channel adjustment menus are hidden.
Each of the eight SDI1 audio input channel pairs delay values are
applied to the input of each channel pair, and the channel pair
adjustment menus become available.
