Hi5-12G Mini-Converter v1.4 12 www.aja.com
Figure 7. Example AJA Mini-Config Screen
Select a USB port and an
attached Mini-Converter
(name in parentheses)
Each connector is
labeled with the signals
currently detected or
manually selected.
Firmware version
Serial Number
Tabbed screens
Message
Showing
Status
NOTE: The LEDs adjacent to each SDI or Fiber connector indicate by color the detected
SDI input signal. Off is no signal, [Green is SD-SDI], [red is HD-SDI], [amber is
3G-SDI], purple is 6G-SDI, [blue is 12G-SDI].
Selecting a Mini-Converter with the pulldown menu causes this application to
connect to the selected converter. The graphic of Mini-Converter and text below
it provides:
• Type of converter
• Firmware version
• Serial number of the unit.
A status field at the bottom of the screen shows if your application is connected
and communicating with the Mini-Converter.
When configuring the Mini-Converter, select it from the top pulldown, view the
current settings and change any values. Making a change communicates that
new value to the Mini-Converter’s non-volatile memory.
Tabbed Screens
The Tabs delineate control screens with groups of controls for each type of task to
be performed. The controls for the actual configuration parameters are specific
to each Mini-Converter type. When you Click on any of the tab buttons, the pane
below the tabs will change to match your tab selection. Any changes you make
are immediately applied and will be saved, overwriting previous settings.