Ki Pro Ultra Plus File Based Recorder/Player v1.0r3 43 www.aja.com
Figure 15. Custom Name Screen with Keypad Active
19.4 Custom Take
This parameter defines a custom take. The custom take number is defined via the
front panel User Control Knob.
1 to 999
(default = 1)
Press the Control Knob and scroll to change the Take value from 1
to 999, if a value other than the automatically generated value
is desired.
22.1 Gang Clip Name
This parameter is used when performing gang recording via multiple Ki Pros and/
or Ki Pro Ultra Pluss (refer to Controlling Multiple Ki Pros later in this manual).
If the desire is to have clips named the same across all Ki Pro ganged units’
recordings, then use the “Master Name” selection in this parameter. If the desire
is to have clips named independently on Ki Pro units, then “Subordinate Name”
should be selected. Selecting “Subordinate Name” means that the recording will
take its name from the individual Ki Pro’s parameters and not accept the value
pushed to the Subordinate by the Master Ki Pro.
Master Name (default)
Subordinate Name
Enable clips to be named the same across all Ki Pro ganged units
Name clips independently on Ki Pro units
NOTE: Most gang controls are only available in the web user interface.
22.4 Captions
This parameter is used to capture of CEA-708 Closed Captioning data as
QuickTime movie tracks.
On recording, Ki Pro Ultra Plus extracts CEA-708 (including 608 within 708)
packets contained in the vertical ANC data embedded in the SDI input (BNC
or Fiber) signal. The packets are processed and inserted into a QuickTime track
(CLCP) as part of the recorded QuickTime container.
Disabled (default)
Enabled
No caption track will be created nor will any arriving captions be
written to the clip.
Writes any captioning data that arrives during the recording into
a QuickTime track (CLCP).
