Ki Pro Ultra Plus File Based Recorder/Player v1.0r3 46 www.aja.com
1.5 Out Convert
This parameter sets output conversion to one of the available selections.
None (default)
2K Crop to 1080
4K Crop to UltraHD
The output is not converted
Converts and crops 2K output to 1080 HD
Converts and crops 4K output to UltraHD
NOTE: The 4K Crop to UltraHD selection has no impact if a 2K or 1080 video source is
used. Also, the 2K Crop to 1080 has no impact if a UltraHD or 1080 video source is
used.
When the Ki Pro Ultra Plus uses its factory defaults, the HDMI output video will
reflect the format of the input video, unless the input signal is either a 4K 50Hz
or UltraHD 50Hz signal and above. In the latter two cases, the video format will
either be 2K or 1920 respectively if downstream the HDMI monitor is not capable
of receiving a YCbCr 4:2:0 stream. Otherwise, the monitor will receive the full
resolution of the video format, except that the YCbCr signal will be 4:2:0 instead
of 4:2:2. The HDMI Out and HDMI/EDID Override menus allows the user to change
the video format and the chroma resolution when the downstream HDMI monitor
does not transmit its EDID, or capabilities, correctly.
The SDI Monitor output, on the other hand, will always decimate the frame size
when the input source is either UltraHD or 4K. Additionally, the user may select
the Monitor Output’s Out Convert option, which will mirror the selection made
in the Out Convert menu, 1.5. In other words, if the input format is 2K, the user
can choose “2K Crop to 1080” option in menu 1.5 and the “Out Convert” option in
menu 1.8 to yield a 1080 output for downstream monitors that cannot accept a 2K
signal.
1.6 SDI Out
(Single Channel Mode only.) This parameter sets the SDI output format. These are
the options:
SDI 1 RGB
SDI 1 YCbCr
SDI 1-2 RGB
SDI 1-2 YCbCr
SDI 1-4 RGB (default)
SDI 1-4 YCbCr
Sets SDI 1 to RGB (supports up to 2K 29.97fps)
Sets SDI 1 to YCbCr (supports up to 2K 59.94fps)
Sets SDI 1-2 outputs to RGB (supports up to 2K 29.97fps)
Sets SDI 1-2 outputs to YCbCr (supports up to 2K 59.94fps)
Sets SDI 1-4 outputs to RGB (supports up to 4K 29.97fps)
Sets SDI 1-4 outputs to YCbCr (supports up to 4K 59.94fps)
NOTE: SDI 1 RGB and SDI 1 YCbCr high frame rates (in excess of 29.97fps) are supported
by 3G-SDI. Be sure to connect the AJA Ki Pro Ultra Plus to a 3G-SDI capable device
in these cases. If a 3G-SDI capable device is not available, RGB and high frame
rate YCbCr may be output via SDI 1 and SDI 2 as “dual link” 1.485Gbps.”
1.64 3G SDI Level
This parameter allows the 3G SDI output to be configured for either Level A or
Level B. While many 3G SDI devices will support both Level A and Level B, some
devices may need a specific 3G SDI selection to operate as expected.
Level B (default)
Level A
For use with devices that accept or require Level B.
For use with devices that accept or require Level A.
