www.aja.com
46
Ki Pro Quad v5.2r3
4.1 ANALOG AUDIO
This parameter configures the analog audio signal levels for input and output. These are
the options:
Professional audio equipment has much higher levels than consumer equipment: a 0 VU
reading corresponds to +4 dBu. Connecting a profes4 dBu device to a consumer
audio input -10dBV (-7.8 dBu) may cause overloading, whereas the output of a consumer
device probably does not have sufficient power to drive a professional audio input. With
consumer and semi-professional audio equipment, a VU reading of 0 dB is typically
referenced to -10 dBV. 0 dBu = 0.775 VRMS. These settings are valid with the panel Mic/
Line switch set to “Line.” (The Mic settings are lower input level settings for use with
condenser and dynamic microphones—use Mic +48 for powered condenser mics and
Mic for dynamic microphones.).
6.1 GENLOCK
This parameter selects the source of reference to genlock to during playback.
NOTE:
Ki Pro Quad always genlocks to the selected video input during capture; genlock may only be
needed during some playback configurations (such as in a facility with a variety of other
equipment).
For general monitoring purposes, genlock is not required. These are the options:
8.0 TC IN
This parameter selects the source of timecode from those available. These are the
options:
8.1 TC VALUE
This parameter selects an hour value from which timecode begins incrementing. These
are the options:
+24dBu (default)
+18dBu
+15dBu
+12dBu
Selects pro-level USA signal levels of +24dBu
Selects pro-level Europe signal levels of +18dBu
Selects pro-level German signal levels of +15dBu
Selects consumer signal levels of +12dBu
Note: Maximum amplitude (0 dBFS)
INPUT
FREERUN (default)
Ref In
Use the currently selected input as the Genlock source
Free run mode: Ki Pro Quad syncs to its own timebase and is
not locked to an external source
Use the Ref Input as the Genlock source
TC VALUE (default)
SDI RP188
LTC
TIME OF DAY
Uses the value specified in parameter 8.1 TC Value
Uses the value from the SDI input
Uses the value from the LTC input
Sets timecode to the device clock value (55.6 Time Set)
00:00:00:00 to 23:00:00:00
(Default: 01:00:00:00)
Use the ADJUST buttons to select a timecode hour.
For example: 01:00:00:00, 02:00:00:00, etc.
