OG-ROI Series openGear card v1.6 28 www.aja.com
For proper operation the input Reference signal must be stable and properly
terminated using a 75-ohm terminator on the last piece of downstream
equipment to which the Ref Video is connected.
On -
Turn on if you have a high impedence incoming reference signal. This will
provide signal termination.
Off -
Turn off (default) if you are not using a high impedence incoming reference
signal.
Reference Source
Select which source you want to use for Reference. Choose from the following:
Free Run -
The OG-ROI Series will lock to its internal clock as the reference source.
Card Ext Ref -
The OG-ROI Series will use the incoming reference source
connected to the Reference Input BNC on the rear panel of the card.
OG Frame Ref 1 -
The OG-ROI Series will use the incoming reference source
connected to the openGear frame’s Reference 1 Input BNC on the rear of the
frame.
OG Frame Ref 2 -
The OG-ROI Series will use the incoming reference source
connected to the openGear frame’s Reference 2 Input BNC on the rear of the
frame.
H-Delay and V-Delay
These controls let you adjust H and V delay from the sync input by dragging the
slider or entering values in the windows on the right. Horizontal delay is entered
in pixels, while Vertical delay is entered in lines.
NOTE: H and V delay adjustments are only available when the SDI Out Format is
compatible with the current sync input reference.
Audio Screen
