OG-X-FR openGear Frame v1.0r1 11 www.aja.com
Figure 4. OG-X-FR — Rear Panel
36
9a+]:
&$87,215,6.2)6+2&
.
'212723(1
5()
/223
5()
/223
36
(7+(51(7
9a+]:
&$87,21
5,6.2)6+2&
.
'212723(
1
2*;)5
1. PS1 Power Supply Connector
This connector is the AC Connector for the main power supply. Refer to the
section
"Connecting to a Power Supply" on page 16
for more information.
2. PS2 Power Supply Connector
This connector is the AC Connector for the redundant power supply.
3. ETHERNET Communication Port
The Ethernet port is an RJ45 connector is used to connect the optional Network
Controller card to an external Ethernet network. This Network Controller card is
required to bridge the external Ethernet network to the local communication bus
for monitoring and control of cards installed in the frame. Only cards with the
Communication bus interface will be able to be monitored and controlled this
way.
NOTE: The Ethernet port does not provide Power-over-Ethernet (PoE).
4. REF Connectors
Two sets of looping BNC inputs are provided to accept two independent
reference signals supporting the following reference signal types: Analog black,
Tri-level sync, and AES/DARS reference.
5. Rear Modules for openGear Cards
The OG-X-FR frame supports module-dependent rear modules. Rear modules
can be ordered with cards, and are easy and quick to install. Blank plates must be
installed if the slots are not populated with openGear cards and rear modules.
openGear Rear Modules
If your OG-X-FR frame was ordered with cards requiring full rear modules or split
rear modules, the appropriate modules are installed at the factory or included
with the cards.
Supports DFR-8321 and OG3-FR Rear Modules
The OG-X-FR frame supports all existing rear modules designed for the DFR-8321
and OG3-FR frames. However, rear modules designed for use in the OG-X-FR
frame are not compatible with other openGear frames.
Identifying an OG-X-FR Rear Module
There are two ways to identify an OG-X-FR frame rear module:
• the notched top of the rear module, and
• a small notch on the bottom left corner of the rear module that fits into a
second seating slot on the midplane of the OG-X-FR frames. Note that this
small notch is not present on other frame rear module types.
