OG-X-FR openGear Frame v1.0r1 41 www.aja.com
2. Install the faceplate by gently fitting it back onto the frame door, ensuring
the faceplate does not interfere with the Diagnostic Panel, the Toggle
button, and the STATUS LED on the frame door.
3. Verify that the side door tabs are seated properly in the cutouts on the
frame door bracket.
4. Using a Phillips screwdriver, secure the faceplate using the four screws
removed during step 1 of the procedure “To remove the old air filter from
the frame door”.
Replacing the Cooling Fan Module
The Cooling Fan Module is installed in the OG-X-FR door. To replace a failed
Cooling Fan Module, you need to replace the entire frame door.
NOTE: Contact your openGear sales representative to order a Cooling Fan Module
Replacement Kit (CFM-OGX).
Replacing the OG-X-FR Door
The CFM-OGX includes the fan board and filter pre-installed in a new OG-X-FR
frame door. You will need to remove the old door from your OG-X-FR frame and
replace it with the new door.
To remove the old door from the OG-X-FR frame
1. Gently pull the side door tabs towards the center of the door, releasing the
door from the frame.
NOTE: The door extender arms retain the door to the chassis.
2. Using both hands, pull the door towards you.
3. Tilt the door upward until the extender arms match the cutout for the
retaining bolts.
4. Gently push the door extender arms in and over the retaining bolts and
unhook from the frame.
5. Remove the door and place it on a clean, flat, static-free surface.
To install the new door in the frame
1. Using both hands, with the door tilted up, slide the new door into the frame
while pushing the extender arms in and over the retaining bolts.
2. Pull and release the door tabs to ensure the:
• frame door is securely locked to the OG-X-FR frame, and
• the tabs latch into the frame.
