ROI Series Mini-Converter v1.5r1 38 www.aja.com
Progress
This indicator bar shows the progress of firmware installation.
Software Update Procedure
1. Check the AJA website for new Mini-Config software for your Mini-
Converter. If new software is found, download it and uncompress the file
archive (zip). Here is the URL to use when checking:
http://www.aja.com/en/products/mini-converters/mini-config-software
2. Connect the Mini-Converter to a Mac or PC via a USB port on the computer
and run the new Mini-Config software just downloaded.
3. Click on the Update tab screen.
4. Check the Installed version level against the Desired version level. If the
Desired is newer, then click the
Update
button to download the new
firmware to the Mini-Converter; progress will be shown via the “Progress”
thermometer bar.
Info Tab Screen
This screen provides basic information about the Mini-Converter. This information
is mostly useful when calling AJA Support for service or technical support.
Name
This field allows you to give your Mini-Converter a name. This can be useful if you
have several Mini-Converters attached to a Mac/PC via USB so you can distinguish
between them easily (especially if they’re the same model).
Type
This is the factory set model name of the Mini-Converter.