You can use the KeyPad Plus without ambient lighting as the keypad has a
backlight. The pressing of the buttons is accompanied by a sound signal. The
backlight brightness and keypad volume are adjustable in the settings. If you do
not touch the keypad for 4 seconds, KeyPad Plus reduces the backlight
brightness, and 8 seconds later goes into power-saving mode and turns off the
display.
If the batteries are discharged, the backlight turns on at the minimum level regardless of
the settings.
Function button
KeyPad Plus has a Function button that operates in 3 modes:
Duress code
KeyPad Plus supports
duress code
. It allows you to simulate alarm deactivation.
installed at the facility will not give you away in this
case, but the security company and other users of the security system will be
warned about the incident.
Two-stage arming
Off
— the button is disabled and nothing happens after it is pressed.
Alarm
— after the Function button is pressed, the system sends an alarm to
the security company monitoring station and all users.
Mute interconnected re detectors alarm
— after the Function button is
pressed, the system mutes the re alarm of the FireProtect/FireProtect Plus
detectors. Available only if an
enabled (Hub
→
Settings
→
Service
→
Fire detectors settings)
