Chapter 3 – Maintenance
Service manual AJP PR3/PR4 3 - 43
evaporate from inaccessible parts of the
engine and the brakes.
Once the motorcycle cools down,
lubricate all moving parts of slide and
support, lubricate the chain with chain
spray.
To prevent malfunction of the electrical
system, the emergency button, the
headlamp control and connectors should
be treated with a spray of electrical
contacts.
! WARNING !
When washing the motorcycle never apply
high pressure water jets directly to certain
sensitive points of the bike, such as electrical
and electronic components, air filter, control
cables, oil cooler, exhaust nozzle orifice, the
steering column bearings and wheels, etc. By
penetrate these components, water (or
humidity) can cause oxidation or corrosion
and bad electrical contacts, causing the bike
malfunction or even lead to premature
destruction of these components.
STICKERS
New sticker’s application
Note:
Please read these instructions
completely before new sticker’s application.
Surface preparation
Remove all stickers and wash carefully
plastics with water and soap.
Remove grease from old stickers with an
appropriate grease remover.
After plastic cleaning, wash your hands and
dry them.
Stickers should be applied in a clean, warm
and dry room.
Application
Start by graphic alignment. On stickers with
holes, start alignment there. On stickers
without holes you can use paper stripes to
help alignment.
Take out one end of protective paper and
start applying it at plastic part.
Do not press immediately with confirming
alignment.
After correctly aligned, continue with paper
removal and sticker application.
Press sticker from inside to borders, to
remove air bubbles.
For a perfect adherence, use a hot air blower
(hair dryer). Apply warm air for 5 seconds at
a 5/7 cm and remove air bubbles again.
Let stickers rest for 48 before any sport or
cleaning activity.
Note:
for a longer sticker’s life, do not apply
water jets over them.
