8
8
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Getting Started (Cont.)
Levelling the appliance
The appliance must be installed level so that it can work properly and the magnetic
doors seals are properly aligned. To level the unit, tilt it slightly backward, then adjust
one or more levelling feet at the base of the cabinet until the unit is level (Fig. 3).
Fig. 3
• Overhanging wall units:
To ensure best performance, if the appliance is positioned
below an overhanging wall unit, the minimum distance between the top of the
cabinet and the wall unit must be at least 100mm. Ideally, however, the appliance
should not be positioned below overhanging wall units.
Setting up
• Cleaning the interior:
Make sure the fridge is disconnected from the power supply
before cleaning the interior. Remove any tape that secured drawers, trays and
shelves during transport. Clean the interior surfaces and all internal accessories with
a damp cloth, moistened in lukewarm water with a mild detergent. This will remove
any dust from transit and storage and help remove the typical smell of a brand new
product. Then dry thoroughly.
CAUTION:
Do not use harsh or abrasive detergents or
powders as these will damage the finish.
•
Before plugging in your new fridge, let it stand upright for at least 4 hours.
This will allow the refrigerant gases to settle into the compressor and reduce the
possibility of a malfunction in the cooling system.
• Connecting the appliance:
Plug the unit into a dedicated, properly installed and
earthed wall outlet.
WARNING!
It must be possible to disconnect the appliance
from the mains power supply; the plug must therefore be easily accessible after
installation. Secure the power supply cord behind the unit. Do not leave it exposed
or dangling to prevent injury and accidental disconnection from the power supply.
• Earthing:
The appliance must be earthed. The plug of the power supply cord is
equipped with a contact for this purpose. Do not under any circumstances cut or
remove the third (earth) prong from the power cord. If the plug does not fit your
outlet, please consult a licensed electrician for advice to have the outlet changed.
