After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
7
Installation
Unpacking
• Packaging materials:
This product has been packaged to protect it against
transportation damage. Remove all packaging materials from around and inside the
appliance and keep the original packaging carton and materials in a safe place. It
will help prevent any damage if the product needs to be transported in the future,
and you can use it to store the appliance when it is not in use. In the event that the
carton is to be disposed of, please recycle all packaging materials where possible.
Plastic wrapping can be a suffocation hazard for babies and young children, so
ensure all packaging materials are out of their reach and disposed of safely.
• Parts:
Check to ensure you have all the parts listed in the Product Overview section.
• Damage:
When unpacking, check the appliance carefully for damage. If it is
damaged, do not install the appliance. Contact our after sales support centre for
advice on examination or return of the damaged appliance.
• Power cord:
Unwind the power cord to its full length and inspect it for damage.
Do not use the appliance if the appliance or its cord have been damaged or are
not working properly. In case of damage, contact our after sales support centre for
advice on examination, repair or return of the damaged product.
• Read the manual:
Before installing your new fridge, read all safety instructions,
especially the sections on installation and electrical safety on pages 4–5. Installation
instructions follow on the next pages.
• Clean:
Make sure the appliance is disconnected from the power supply before
cleaning the interior. Remove any tape that secured drawers, trays and shelves
during transport. Clean the interior surfaces and all internal accessories with
lukewarm water, a soft cloth and a neutral/mild soap/detergent. This will remove
any dust from transit and storage and help remove the typical smell of a brand new
product. Then dry thoroughly.
CAUTION:
Do not use harsh or abrasive detergents or powders as these will
damage the finish.
