English
- 50 -
Note: You can use YPbPr to VGA cable (not supplied) to enable YPbPr signal via VGA input.
WARNING: You cannot use VGA and YPbPr at the same tim
5. SPDIF Out
outputs audio signals of the currently watched source.
Use an
SPDIF cable
to trasfer audio signals to a device that has SPDIF input.
Viewing the Connections - Side Connectors
1.
The CI Slot is used for inserting a CI card. A CI card allows you to view all the channels
that you subscribe to. For more information, see “Conditional Access” section.
2.
Side USB input.
3. Side audio-video connection
input is used for connecting video and audio signals of
external devices. To make a video connection, you must use the supplied AV connection
cable for enabling connection. First, plug the single jack of the cable to the TV’s Side AV
socket. Afterwards, insert your video cable’s (not supplied) connector into the YELLOW
input (located on the plural side) of the supplied AV connection cable. The colours of the
connected jacks should match.
To enable audio connection, you must use RED and WHITE inputs of the side AV
connection cable. Afterwards, insert your device’s audio cable’s connectors into
the RED and WHITE jack of the
supplied
side AV connection cable. Colours of the
connected jacks should match.
4.
The headphone jack is used for connecting an external headphone to the system.
Connect to the HEADPHONE jack to listen to the TV from headphones.
5.
The Control switch allows you to control the Volume/ Programme/ Source and Standby-
On functions of the TV.
To change volume:
Increase the volume by pushing the button up. Decrease the volume
by pushing the button down.
To change channel:
Press the middle of the button, the channel information banner will appear on screen.
Scroll through the stored channels by pushing the button up or down
To change source:
Press the middle of the button twice, the source list will appear on screen. Scroll
through the available sources by pushing the button up or down.
To turn the TV off:
Press the middle of the button down and hold it down for a few seconds, the TV will
turn into standby mode.
Aerial Connection
• Connect the aerial to the
AERIAL INPUT (ANT)
socket located at the rear of the TV.
H
M
I 1
D
SPDIF
Coax. UT
O
Aerial or Cable
Power Connection
IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.
MO
DE o
