Version 1.00
49
INPUT ROUTING
INPUT ROUTING - DD8 (or DD8plus)
When a DD8 (or DD8plus) is selected on entry to the ROUTE INPUTS pages, the screen will
change to allow control of the input architecture on these machines:
This shows the default routing in a system with analogue inputs. When the cursor is over the
INPUT TYPE field, you can select between ANALOGUE or DIGITAL inputs using the DATA ENTRY
+/- keys.
Inputs may also be routed to tracks using the cursor up/down/left/right keys to move to a matrix
point. You then use the DATA ENTRY +/- keys to assign or de-assign accordingly. For example, to
route INPUT 3 to track 6, move the cursor to 6 using the cursor right key and use the cursor down
key to select INPUT 3. The cursor looks like this and shows you where you are. To the right of the
screen, the input you have selected and the track you are on is also shown.
The cursor is shown and the track number is highlighted. The selected track and input are also
shown to the right of the screen - in this case, TRACK 6 INPUT 3. To route this input to the selected
track, press the DATA ENTRY+ key. You will see this screen:
INPUTS
IN 1/2
IN 3/4
IN 5/6
IN 7/8
Input type : ANALOG
Track
6
Input
3
RESET
1
2
4
5
7
8
3
6
This shows that INPUT 3 is now routed to tracks 3 and 6.
The RESET (F6) key may be used to restore the default routing (input 1 goes to track 1, input 2
goes to track 2 etc..).
Summary of Contents for RE32
Page 10: ...Page ix ...
