Before Operation
Assembly
1.
Carefully place the platter on the center spindle, and align one of its openings over
the motor pulley position (Fig.1)
2.
Tear the fiber tape off.
3.
While holding both ends of the ribbon on the turntable belt, carefully pull the belt
over the motor pulley (Fig. 2). Be sure it does not twist.
4.
Remove the ribbon.
5.
Once the belt is seated in the pulley’s groove, as Fig.2, the fiber tape can be torn off.
6.
Remove another one ribbon (Fig.3).
7.
Place the mat on top of the platter (Fig.4).
8.
Remove the tie securing the tonearm (Fig.5a).
9.
Remove the stylus guard (Fig. 5b)
.
Fig.1
Fig.2
Fig.3
Fig.5
Fig.5a
Fig.5b
Fig.4
15
