Akai VS-K203M-E7, Operating Instructions Manual

14

VCR

1

Load a pre-recorded cassette tape. When loading

2

To rewind the tape or forward it rapidly

a cassette tape without an erase
prevention tab, playback will start
automatically.

 Press 

. Playback will start.

To stop playback

Press 

.

To rewind the tape:

Press 

.

To forward the tape:

Press 

.

Forward/reverse picture search mode

When the tape is being transported you can switch to
picture search mode (see next page). To do this,

press  

 or 

 and hold it down. The unit will

resume the tape transport as soon as the button is
released.

NTSC Video cassette-Playback

When using a pre-recorded NTSC video cassette
tape, the connected TV set must operate with a 60
Hz vertical frequency. Otherwise the on-screen
picture will be affected by vertical rolling. Even if your
TV set is capable of processing NTSC video signals,
the picture may be shortened vertically (appearance
of black bars at the top and at the bottom of the TV
screen). The dubbing of a NTSC video cassette tape
to a standard PAL VCR is not possible.

Turn on the TV, and select the AV-program position
on TV.

Preparation

If the cassette has not
loaded yet,      will blink
for 4 seconds.

VCR

VCR

VCR

VCR

ATR

Use only video cassette tapes marked
.Loading

Push the center of the tape until it is automatically
inserted.

Insert the cassette tape with its labeled side facing
up and the erase prevention tab positioned at your
left. An inverted cassette tape cannot be inserted.

Screwdriver

To prevent accidental erasure

Remove the erase prevention tab with a screwdriver.

Automatic tape eject
When the VCR is automatically rewinding the tape
and reaches its beginning, the cassette tape will be
ejected automatically.

OR

:

Unloading

2

1

Press STOP/EJECT on the VCR. When a tape
is being played press this button twice.

Remove the cassette tape.

Automatic playback
When loading a cassette tape without an erase
prevention tab, playback will start automatically.

Automatic power ON
When you insert a cassette tape the VCR power will
turn ON automatically.

Press EJECT on the remote
control. Even if a tape is
being played, press this
button only once.

Loading and Unloading a Cassette Tape / Playback

inspelningsskydd

Erase prevention tab

VCR

VCR

VCR

Adhesive
tape

To record again

Cover the hole with a piece of adhesive tape.

Loading and Unloading a Cassette Tape

Playback

 4F37001A (E)P10-15

5/6/2002, 16:41

14