螺栓固定:安装在带有安装孔的边框上。如果风压雪压不是很大,可按照图示箭头选择内侧4个安装孔用于安装,
组件可承受正
反1600Pa 的风压
。当风速超过130km/h,雪压超过2400Pa时,边框上8个所有的孔都须用于安装。
Bolt fixing: The installation should be fulfilled using the installation holes already on the frameIf the wind or snow
pressure is not much, four installation holes may be used,
Module can withstand wind pressure of 1600Pa on both
sides
. When wind speed is higher than 130km/h or snow pressure is higher than 2400Pa, all the eight installation
holes should be used.
组件安装
Mounting Instruction
02
08
注:测试载荷= γm(安全因子) × 设计载荷,γm=1.5
Note: Test load = γm(safety factors) × design load,
γm=1.5