N
No
otte
e::
Refer to fig. 3/5a.
Refer to fig. 3/5b
4
4..2
2 P
Pu
uttttiin
ng
g tth
he
e
M
Miiccrro
op
ph
ho
on
ne
e O
On
n
Figs. 4 through 6:
Putting on and tighten-
ing the headband.
(The cover (4) stabilizes the temple piece and prevents your
hair from getting caught in the wire loop.)
5. Press the cable back into the cable holder (5).
Two Alternative Ways to Route the Cable
a) To fix the cable more tightly inside the cable holder, you can
reeve the cable through the cable holder twice. Make sure
to leave enough slack in the rest of the cable so you can still
readjust the behind-the-neck headband.
b) Set the behind-the-neck headband to its smallest size and
route the connector and cable through the behind-the-neck
headband wires.
1. Set the behind-the-neck
headband to its largest
size by pulling the two
wires apart all the way.
2. Put the behind-the-neck
headband on as shown in
figs. 4 through 6.
3. If necessary, slide the
head band wires inward to the point that the microphone will
rest securely yet comfortably on your head.
4. Should the microphone still fit loosely even at its smallest
size, you can bend the behind-the-neck headband and the
temple pieces inward:
4 Using Your Microphone
20
AKG HC 577 L
4
5
6
