08182020JA
www.akiascreens.com
U-00205
6
Edge Trim Installation
Step
9
: Place the edge trim frame pieces over each end of the frame.
Connect edge trim frames (
e/f
) together using the
M4
center joint (e)
and secure with four of the
M4x4 screws (m)
as show in
Step 1
. Repeat for other side.
Once both top and bottom edge trim frames have been connected, attach the vertical (left/right) sides edge trim
frames (
d
) using the
elbow joints
(
f
) and secure with four
M4x4 screws
(
m
) on all corners,
Step 2
.
Step 10
: Install the
angle cover
(
n
) on each corner of the frame using the
M4x4 screws (m)
.
Note: The angle cover screws holes align with the screw holes on the elbow joint.
1
1
2
2
2
2
f.
m
e.
m
.
n.
Tear off the double-sided tape.
ATTENTION: The back of the material has labels indicating the TOP and BOTTOM. The top edge trim piece with the
logo should be installed at the top. The material is directional and will not accurately reflect if bottom side is projected on.
