3
Unscrew handle counter clockwise by hand, then unscrew
Screws using screwdrive, take out handle.
Remove handles. Unscrew Dome Cap counter clockwise
by hand. Unscrew Retaining Nut using adjustable wrench,
take out cartridge assembly and inspect. Replace parts
as necessary. Reassemble parts by reversing steps.
Handle Removal Maintenance
Valve Cartridge Removal Maintenance
INSTALLATION PROCEDURES
You should clean all the dirts from valve outlets.
Turning off the water supply valves. This is usually
found near the water meter. If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the O-RING
is placed onto the bottom of Base Ring. Install
faucet through hole in sink. From underside sink,
put Plastic Washer and Mounting Nut. Position
faucet on sink properly and tighten Mounting Nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
2
1
2
3
4
6
Turn both handles fully clockwise to the off position.
5
Use the flexible hose to connect the faucet to the water
supply valve. (Another purchase of flexible hose)
Turn on the water supply to the faucet and check for
leaks.
8
7
Remove the aerator and open both handles to flush
debris from the faucet.
Turn off the water and reinstall the aerator.
