-
4
-
Model No.: VCR-S407
Version: 1.0
IMPORTANT SERVICE GUIDE
MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT
1) When installing the ass’y deck on the Main PCB, be sure to align the assembly point of mode
switch.
HOW TO EJECT THE CASSETTE TAPE
(If the tape is stuck in the unit)
1 Turn the Gear Worm clockwise in the direction of arrow with screwdriver. (See Fig. 2)
(Other method ; Remove the screw of Motor Load Ass’y, Separate the Motor Load Ass’y)
2 When Slider S, T are approaches the unloading position, rotate holder Clutch counter clockwise
after inserting screwdriver in the frame’s bottom hole in order to wind the unwound tape. (Refer to
Fig. 3)
3 (If you rotate Gear Worm continuously when tape is unwinding, you may cause tape contamination
by grease and tape damage. Be sure to wind the unwound tape with the unit in the horizontal
position.)
4 Rotate Gear Worm clockwise using a screwdriver until the mecha is in the eject state. Remove the
tape. (Refer to Fig. 2)
Summary of Contents for VCR-S407
