the room temperature，the thermostat button can be turned from 0 to 270 degree.
THERMOSTAT INSTRUCTIONS
At first turn the thermostat to “Max” and let the heater operate with full power
input. When the room temperature reaches the required value, turn the thermostat
to left until it switches off.
The thermostat will then switch on and off automatic to control the room temperature
according to the preset value and keep the room temperature constant.
When using the heater for the first time, you may notice a slight emission of smoke.
This is quite normal and it stops after a short time. The heating element is made
of steel and was coated with a layer of protection oil by production. The smoke is
caused by the left oil when heated.
After the use turn the thermostat to OFF position and turn the selector switch to
Fan level, let the appliance cool down for two minutes. For appliances with time
delay stopping function, even the power switch is off, the delay circuit may turn
on the appliance if the inner temperature reached the preset function value. The
delay time depends on the ambient temperature. For 20
C ambient it is ca. 3-4 minutes.
If the ambient temperature keeps being more than 27
C so the delay device can not
cool down, the delay time may be very long or the delay circuit doesn’t open，
hereby the user can only disconnect the appliance from the power supply by pulling
out the plug.
Installation case Illustrate:
Use M5X22 Screw 、Ø5 spring washer、 Ø5x10 flat washer fit on shell，
Tighten the M5X22 screw.
Connect with duct Installation case Illustrate
