Hard Disc Installation.
Removal.
Like any other mechanical device the HDD may fail at some time. It is possible to replace the HDD for
another of the same capacity or a larger HDD (up to 500G bytes).
Ensure the PVR is turned off and fully disconnected from any other apparatus.
Place on a firm stable surface and Remove the screws as shown in
Fig 26.
23
HDD Installation
Lift the cover gently, and ease the HDD from its enclosure. Carefully unplug the 40 pin ribbon cable
and 4 pin power lead.
Unscrew the 6 screws mounting the HDD to the base plate.
Replacement.
Place the new HDD into the base plate and replace the mounting screws.
Before connecting the leads, ensure the HDD is configured correctly. Check the jumper connection is
set to “MASTER”
( Fig 27.
Re connect the ribbon lead and power plug and carefully re insert the HDD into the PVR.
Replace the screws and you are ready to reconnect the PVR to its
other apparatus and mains power.
Formatting.
Before you can record to the HDD it must be Formatted.
Enter the Main menu by pressing the “MENU”
button.
Select “DTR Setting”
using the
▲
/
▼
buttons and press “OK”
Select “Format Hard Disc”
and press “OK”. A warning message will be displayed, press “OK”
and enter
the Pin Number (6666 is the factory default). The HDD will now be formatted in a few seconds
depending upon the size of the drive.
When formatting is completed the PVR is ready for use.
Fig 27
Fig 26